DDUNIT SETTING IN AUTO CAD BY BUDI MARYANTO

Drawing a building in accordance with what we expect is not an easy thing. From planning, to interior and exterior models we may need a lot of time and consideration to complete. But one thing that is not less important in making drawings of the building must not be separated from the unit unit. Because this unit unit would you use to adjust the size of the system in the image of a building that have previously been planned.

We can control the type of notation units we need.

AutoCAD on the state of wear standard decimal notation in

determine the coordinates, distances, and angles. However, the choice

Other notations are also available.

steps for setting unit unit is:

1. Open autocad then> new file (Ctrl N)

2. Type DDUNITS units or on the command line to run the command, then press enter so that units Drawing dialog box appears.

Figure 1.3 Drawing Units Dialog Box

3. Make sure the Length group, we choose to type Decimal and precision we pilih0.00.

4. At Angel group, we choose to type the decimal precision Degrees and 0.

5. For Clockwise left blank.

6. For Insertion scale we choose units milimeters.

Well after all the settings are finished and then we select ok to close the dialog box. Thus we have succeeded in setting up units Units that will be used for system sizes in our drawing.

Description:

1. Length - Type, allowing us to determine or select the unit system that we use.

2. Precision, the level of precision of our chosen unit can be determined by pressing the arrow in the lower precision.

3. Angle - Type, to determine the precise level of the system and have the same way with Length - Type.

4. Direction, to determine the direction of the corner. In AutoCAD used "counter clockwise" or berlawananarah clockwork.

5. Can we assume the value of the unit by kebutukan kita.Contoh: 1 units can be considered as 1 meter or 1 cm or 1 inch, and so on. This relates to the international standards used reference pencetakan.Dalam 1 unit = 1 mm. We can control the type of notation units we need. AutoCAD on the state of wear standard decimal notation dalammenentukan coordinates, distance, and

             angle. However, another notation options available as well.